
B/26
Mod. Apollo
Safety Regulations
Charged
battery
Flat
battery
Engine block
to start
Connecting the cables and starting the engine
1. Ensure the ignition key is in position “O”.
2. Connect the positive poles “+” on the two batteries “A”.
3. Connect the cable on the negative terminal “-“ of the charged
battery to the ground block on the machine to be started up “B”.
4. Start up the engine of the machine that is working properly
and rev up the engine.
5. Start the engine of the machine that has broken down.
Removing the cables
With the engine running, remove the cables in the reverse
order in which they were connected.
1. Disconnect the negative cable (-) from the ground block on
the started engine and then from battery “B”.
2. Disconnect the positive cable “+” first from the battery used
to start up and then from the battery of the machine with the
flat battery. “A”.
- ATTENTION -
ALL THESE PROCEDURES MUST BE CARRIED OUT BY
COMPETENT AND TRAINED STAFF.
ELECTRICAL SYSTEM OVERLOAD PROTECTION
- ATTENTION -
Burnt fuses must be replaced with another fuse of the
same type.
Other types of repairs are forbidden, even if temporary.
- Do not connect or remove terminals, fuses or connectors
while the machine is running or being electrically powered.
- ATTENTION -
Any work on the electrical system must be carried out
while the machine is disconnected from the power supply.
Do not restore the power supply until the work has been
completed and all covers and protection devices have
been reassembled.
- Act on the battery cut-out to disconnect the power sup-
ply to the machine.
- Also disconnect the power supply by acting on the batte-
ry cut-out before replacing the battery.
- If a connector is damaged or no longer enters its housing,
replace immediately to avoid short circuits, sparks, etc.
- ATTENTION -
Damaged, pinched or burnt cables must be replaced im-
mediately even if the damage only concerns the sheath
or external insulation.
- Never connect or disconnect the charge circuit (inclu-
ding battery connections) while the engine is running.
- Never short circuit at the ground (earth) any charge
components.
- Do not use an auxiliary battery with a rated voltage abo-
ve 12 Volts.
- Always ensure the polarity is correct when installing bat-
teries or using an auxiliary battery to start up using jump
cables. Comply with the instructions in the use and main-
tenance manual when starting the machine with jump ca-
bles. Connect positive to positive and negative to negative.
- Always disconnect the negative cable from the batteries
before carrying out any arc welding on the machine or
any attachments connected to it.
- Position the welder ground terminal as close as possible
to the area to weld.
- ATTENTION -
If the welding needs to be carried out near an electrical
module, the module must be removed from the machine.
Ensure this procedure is carried out by qualified and
authorised personnel.
- Ensure the welder cables are not above, near or cross
any electrical cables or electronic components while
welding is being carried out.
Kommentare zu diesen Handbüchern