CAB Apollo 1 Bedienungsanleitung PDF herunterladen (Seite 9)

cab - Produkttechnik GmbHENG-8

Adjustment of the Label Edge Sensor

To accommodate a variety of print jobs, the position of the label edge sensor (1)

can be adjusted at right angles to the path of the paper feed.

It is important to ensure that the sensor is positioned in a way that the gaps

between the labels or the markings can be recognized by the photocell. (the

position of the sensor is marked by a notch in the sensor holder).

Adjust the sensor position using the knurled knob (2).

By turning the knob clockwise the sensor moves outwards, and by turning the knob

counter-clockwise the sensor moves inwards.

Adjustment of the Transfer Ribbon

If creases, lines or black patches appear in the print image resulting in a poor print

quality, this may be caused by wrinkles in the transfer ribbon (1). To remove the

wrinkles, the tension of the ribbon should be made even from the left to the right by

moving the ribbon shield (4) up or down.

1. Loosen the locking screw (3).

2. Shift the transfer ribbon shield (4) sideways into the direction of the wrinkle.

Moving it to the left will increase the tension on the left.

Use the scale (2) provided to monitor the adjustments made. If the screw is in

position "1", the tension is highest on the outside, and if it is in position "5", the

tension is highest on the inside.

3. After completing the adjustment, tighten the locking screw (3).

1 2

2 1

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

Keine Kommentare

CAB Apollo 1 Bedienungsanleitung Seite 9