CAB Apollo 1 Bedienungsanleitung PDF herunterladen (Seite 28)

ENG-27cab - Produkttechnik GmbH

1. Switch OFF the printer.

2. Connect the 15-pin SUB-D plug (2) at the back side of the cut/peel-off

adapter (1) to the peripheral port (3) of the Apollo.

3. Mount the cutter assembly (7) or the present sensor as described in the

previous chapters contact the cable (6) to the 15-pin SUB-D connector (5)

at the front side of the cut/peel-off adapter.

4. Plug the cable of the external release switch to the 9-pin SUB-D connector

(4).

5. Switch ON the printer.

Make sure, that the external release switch is open (no voltage at

Pin 1 of the 9-pin connector) when the printer is switched ON.

6. Start a print job in the cut or peel-off mode.

7. Release the print of single labels by actuating the external switch.

Installation and Operation

Pin 5/6 - Pin 5 : Internal operating voltage +24V ; Pin 6 : Ground

The operating voltage can be used to generate the external start signal with a

switch.

The use of this voltage for other purposes is prohibited.

Pin 7/8/9 - n.c.

Inputs and outputs are designed with optocouplers, i.e. they are potential free in

relation to the Apollo. The isolation voltage is 500 V. The voltage at the outputs

should not be higher than 30V.

1 2 3 4 5 6 7

1 2 ... 23 24 25 26 27 28 29 30 31 32 33

Keine Kommentare

CAB Apollo 1 Bedienungsanleitung Seite 28