CAB Apollo 1 Bedienungsanleitung PDF herunterladen (Seite 22)

ENG-21cab - Produkttechnik GmbH

Rewinding Operation

1. Attach the rewinder to the Apollo by positioning the metal posts on the bottom

of the rewinder (5) into the holes of the adapter plate (4).

2. Feed the label strip over the guide bar and under the roller onto the rewinder

axle (6) as shown in the left upper figure. Considering the required method of

rewinding, secure the label strip appropriately to the rewinder axle (6) by sliding

the clamp (7) over the label strip with the clamp set in the groove. (the broken

line shows the path of inside rolled labels)

Ensure that the label strip is even with the disc (1).

4. Slide the clamp (7) as far as possible towards the disc (1).

5. Slide the flange (3) onto the rewind axle (6) so that it slightly touches the label

strip. The label strip must be able to move slightly between the disc and the

flange.

6. Tighten knurled screw (2) in the flange (3).

7. Switch the rewinder ON.

Caution ! When switched ON, the rewinder immediately starts rotating !

21 3

457 6

Rewinding Directly onto the Rewind Axle

1. Use a cardboard roll (8) which is about .04 in (1 mm) wider than the label strip.

2. Attach the rewinder to the Apollo by positioning the metal posts on the bottom of

the rewinder (5) into the holes of the adapter plate (4).

3. Mount the first axle adapter (9) onto the rewinder axle (6) and slide it up to the disc

(1). Tighten knurled screw (10).

4. Mount the second adapter onto the rewinder axle (6). Slide it towards the first

adapter until the clearance between the edge of the adapter and the disc (1) is a

little less than the width of the cardboard roll (8). Tighten knurled screw (10).

5. Slide the cardboard roll (8) over the two adapters (9) until it is touching the disc (1).

6. Feed the label strip over the guide bar and under the roller as shown in the right

upper figure up to the cardboard roll (8).

7. Using adhesive tape or a label, affix the end of the label strip to the cardboard roll

(8). (the broken line shows the path of inside rolled labels)

8. Slide flange onto the rewind axle (6) until it stops at the cardboard. Tighten

knurled screw.

9. Switch the rewinder ON.

Caution ! When switched ON, the rewinder immediately starts rotating !

Rewinding on to 3 in (75 mm) Cardboard Rolls

1 6

458910

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 32 33

Keine Kommentare

CAB Apollo 1 Bedienungsanleitung Seite 22