CAB Apollo 1 Bedienungsanleitung PDF herunterladen (Seite 8)

ENG-7cab - Produkttechnik GmbH

Adjustments Concerning the Labels

The printer can use a variety of media widths an thicknesses.

Beside it is possible to use materials which have punch holes and reflective marks

for the label recognition.

For this reason it is necessary to adapt the printer to the different materials by

only a few simple adjustments.

Adjustment of the Printhead Support

When printing narrow labels (width less than 2.5 in or 60 mm), it is possible that the

printhead will come into direct contact with the drive roller. This will lead to

premature wear on the printhead. In addition, the printhead will be at a slight angle

to the label, thus, the uneven pressure may result in an inconsistent image density

from one edge of the label to the other.

To correct this problem, the printhead support (4) may be adjusted.

Adjust printhead support as follows :

1. Loosen the locking screw (2).

2. Move the locking screw (2) as required within the adjustment slot (3). This will

cause the cam shaped printhead support (4) to rotate, in effect, providing a

higher or lower base on which the printhead mounting (1) rests.

3. It is convenient to use the position 2a to printout large labels. The printhead

support (4) is total inactiv here.

4. By using small labels it is necessary to adjust the printhead support. In this

case insert a second strip of the label at the front side of the print roller. Now

slide the locking screw (2) as far as possible to position 2b in the adjustment

slot (3), until the printhead support (4) touches the printhead mounting (1).

Take away the second label strip.

5. Tighten the locking screw (2).

Apollo 1 Apollo 2 Apollo 3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 32 33

Keine Kommentare

CAB Apollo 1 Bedienungsanleitung Seite 8