CAB A8+ Betreibershandbuch PDF herunterladen (Seite 41)

41cab Produkttechnik GmbH & Co KG

Fig. 7d Feed path in Tear-off Mode

10. Slide the media guide ring (7) inward until it lightly touches the side of the

media strip.

4. Place the label roll (9) onto the adapters media hub and slide it against the

chassis (15). Unwind a strip of media (4) from the media roll. When

operating in the rewind mode make sure that the strip is long enough to

reach the internal rewinder (16) by guiding the strip through the whole print

mechanism and underneath of it. Make sure the labels between the

media hub and the print mechanism are facing up.

5. Swing the media retainer (14) downwards until it touches the media hub

(10). Push the media retainer against the supply role until it rests against

the label media. Tighten the knurled screw (13).

6. Raise the printhead assembly (2) by rotating the lever (5) clockwise until it

stops.

7. Swing down the plate (8).

8. Slide the media guide ring (7) outward, allowing enough clearance for the

label stock's width when loaded.

9. Slide the media strip underneath the swing (6) and through the adjustable

photocell assembly (3) until it comes out of the front of the printer. If you

are using labels that are wound-in, please make sure that you slide the

media strip over the internal rewind hub (16).

In figure 7d the feed path for labels wound-out is represented by a solid

line, and the feed path for wound-in labels is represented by a broken line.

7. Media Loading

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 119 120

Keine Kommentare

CAB A8+ Betreibershandbuch Seite 41